Skip to content
EndsemMay 20252019 patternFE

Engineering Graphics (EG) SPPU Endsem Question Paper May 2025

All 8 questions from this SPPU endsem paper, as printed. Read them here or open the PDF.

Open the PDFMost repeated EG questions
Subject code
102012
Pattern
2019 pattern
Exam
Endsem
Session
May 2025
Max. marks
50
Time
2½ Hours
Semester
I/II
Paper code
[6401]-1910

Printed for: F.E.

Instructions to the candidates

  1. Solve Q.1 or Q.2, Q.3 or Q.4, Q.5 or Q.6, Q.7or Q.8.
  2. Assume suitable data, if necessary.
  3. Retain all the construction lines.

Questions

  1. Q1

    1. Draw an ellipse by rectangular method if the major axis and minor axis are 100mm and 70mm respectively.

      Also asked:May 2023

      [8]

  2. Q2

    1. Draw Involute of a circle having 50 mm diameter and String length is equal to the circumference of circle.

      [8]

  3. Q3

    1. Figures shows a pictorial view of an object. By using first angle method of projection, draw sectional Front View in the direction of X, Top View and Left-Hand Side View. Give dimensions in all views.

      Also asked:May 2023

      [16]

  4. Q4

    1. Figure shows the pictorial view of an object. By first angle method of projection draw :

      [16]
    2. a)

      Sectional Front View in the X direction shown by S

      Also asked:Feb 2026 ·Nov 2024 ·Nov 2023 ·May 2023

    3. b)

      Top View

    4. c)

      Right-Hand Side View

      Also asked:Feb 2026 ·Apr 2025 ·Nov 2024 ·Nov 2023

  5. Q5

    1. Figure show orthographic views of an object by first angle method of projection. Draw its isometric view and give all the dimensions.

      [16]

  6. Q6

    1. Figure show orthographic views of an object by first angle method of projection. Draw its isometric view and give all the dimensions.

      [16]

  7. Q7

    1. Draw the development of surface of the cone having base diameter 50 mm and axis height 70 mm. If it is cut by cutting plane which bisects the axis of the cone and inclined at 45° with HP.

      [10]

  8. Q8

    1. Draw the development of lateral surface of pentagonal prism of base side 35 mm & axis height 80 mm, has its one side of base is parallel to VP and corner is nearer to observer. It is cut by a cutting plane which is inclined at 30° to the HP and bisecting the axis of cylinder. 

      [10]