Skip to content
EndsemMay 20232019 patternTE Mech

Metrology and Quality Assurance SPPU Endsem Question Paper May 2023

This 2019-pattern Metrology and Quality Assurance paper is listed under Metrology and Quality Control. All 8 questions are below, as printed.

Open the PDFMost repeated MQC questions
Subject code
211511
Pattern
2019 pattern
Exam
Endsem
Session
May 2023
Max. marks
70
Time
2½ Hours
Semester
IV
Paper code
[6002]-242

Printed for: S.E. (Robotics & Automation)

Instructions to the candidates

  1. Answer Q.1 or Q.2, Q.3 or Q.4, Q.5 or Q.6, Q.7 or Q.8.
  2. Neat diagrams must be drawn wherever necesary.
  3. Figures to the right indicate full marks.
  4. Assume Suitable data if necessary.
  5. Use of Logarithmic Table, Slide rule is Electronic pocket calculator is allowed.

Questions

  1. Q1

    1. a)

      With neat sketch explain the working principle of tool maker’s microscope.

      Also asked:May 2024

      [8]
    2. b)

      Explain effective diameter measurement by three wire method.

      [9]

  2. Q2

    1. a)

      Explain screw thread terminology.

      [8]
    2. b)

      Explain the use of profile projector with neat sketch.

      [9]

  3. Q3

    1. a)

      Explain X -Chart & R-Chart.

      [8]
    2. b)

      Contrast between Acceptance Sampling Vs 100% Inspection.

      [9]

  4. Q4

    1. a)

      Explain Operating Characteristic Curve (OC Curve).

      [8]
    2. b)

      This part has equations that don’t show as text. Open the PDF to read it.

      [9]

  5. Q5

    1. a)

      Explain Juran’s Trilogy with neat sketch.

      [9]
    2. b)

      Write a short note on: i) Quality Circle ii) Six Sigma iii) TPM

      [9]

  6. Q6

    1. a)

      Explain in detail TQM and its importance.

      [9]
    2. b)

      Explain following QC tools. i) Pareto Chart ii) Control Chart iii) Stratification

      [9]

  7. Q7

    1. a)

      Explain the benefit if environment management system.

      [9]
    2. b)

      Explain ISO 9000 and its importance.

      [9]

  8. Q8

    1. a)

      Explain the concept of Quality Management System (QMS).

      [9]
    2. b)

      Explain the concept of ISO 14000. 

      Also asked:May 2025

      [9]