Skip to content
InsemMar 20262019 patternTE Mech

Metrology and Quality Assurance SPPU Insem Question Paper Mar 2026

This 2019-pattern Metrology and Quality Assurance paper is listed under Metrology and Quality Control. All 10 questions are below, as printed.

Open the PDFMost repeated MQC questions
Subject code
211511
Pattern
2019 pattern
Exam
Insem
Session
Mar 2026
Max. marks
30
Time
1 Hour
Semester
IV
Paper code
APR-26/SE/Insem-312

Printed for: S.E. (Robotics and Automation) (Insem)

Instructions to the candidates

  1. Solve Q.1 or Q.2 and Q.3 or Q.4, Q.5 or Q.6, Q.7 or Q.8, Q.9 or Q.10 .
  2. Assume suitable data if necessary.
  3. Figures to the right indicate full marks.
  4. Draw neat figures whenever necessary
  5. Use of scientific calculators is allowed.
  6. Use of cellophone is prohibited in the examination hall.

Questions

  1. Q1

    1. Differentiate between line standard and end standard.

      Also asked:Mar 2025 ·Mar 2023

      [5]

  2. Q2

    1. Define Metrology and enumerate the objectives of metrology

      Also asked:Mar 2025

      [5]

  3. Q3

    1. Explain with diagram the uses of sine bar and sine centre.

      Also asked:Mar 2025

      [5]

  4. Q4

    1. plain with neat sketch the construction and working of Auto-collimator.

      Also asked:Mar 2025

      [5]

  5. Q5

    1. Differentiate between Hole Basis and Shaft Basis system

      Also asked:Mar 2025 ·Mar 2024

      [5]

  6. Q6

    1. Explain with neat sketch Construction of Sigma Comparator.

      Also asked:Mar 2025

      [5]

  7. Q7

    1. Show schematically difference between Allocation of gauge tolerance and wear allowance for plug and ring limit gauges 2 APR-26/SE/Insem-312

      Also asked:Mar 2025

      [7]

  8. Q8

    1. State Taylor’s principle of gauge design. List out types of limit gauges used in industry.

      Also asked:Mar 2025

      [7]

  9. Q9

    1. Design workshop type limit gauges for checking 80H 8 . Given

    2. a)

      This part has equations that don’t show as text. Open the PDF to read it.

    3. b)

      This part has equations that don’t show as text. Open the PDF to read it.

      [8]

  10. Q10

    1. Design limit gauges for checking 90 h 9 shaft. Given

    2. a)

      This part has equations that don’t show as text. Open the PDF to read it.

    3. b)

      This part has equations that don’t show as text. Open the PDF to read it.

      [8]