Skip to content
InsemMar 20242019 patternTE Mech

Metrology & Quality Assurance SPPU Insem Question Paper Mar 2024

This 2019-pattern Metrology & Quality Assurance paper is listed under Metrology and Quality Control. All 4 questions are below, as printed.

Open the PDFMost repeated MQC questions
Subject code
211511
Pattern
2019 pattern
Exam
Insem
Session
Mar 2024
Max. marks
30
Time
1 Hour
Semester
IV
Paper code
[6268]-260

Printed for: S.E. (Robotics & Automation) (Insem)

Instructions to the candidates

  1. Answer Q.1 or Q.2, Q.3 or Q.4.
  2. Neat diagrams must be drawn whenever necessary.
  3. Figures to the right indicate full marks.
  4. Assume suitable data, if necessary.
  5. Use of Logarithmic Table, Slide rule is Electronic pocket calculator is allowed.

Questions

  1. Q1

    1. a)

      Write short note on Slip Gauges.

      [9]
    2. b)

      Differentiate between Accuracy & Precision.

      [6]

  2. Q2

    1. a)

      State the advantages & disadvantages of Optical comparator.

      [6]
    2. b)

      Write short Note on Auto Collimator.

      [9]

  3. Q3

    1. a)

      Explain with neat sketch NPL interferometer.

      [8]
    2. b)

      Sketch & interpret the meaning of various interference fringe patterns observe using optical flats.

      [7]

  4. Q4

    1. a)

      This part has equations that don’t show as text. Open the PDF to read it.

      [10]
    2. b)

      Differentiate between hole basis system & shaft basis system. 

      Also asked:Mar 2026 ·Mar 2025

      [5]