Skip to content
InsemOct 20222019 patternBE E&TC

Electronic Product Development (EPD) SPPU Insem Question Paper Oct 2022

All 4 questions from this SPPU insem paper, as printed. Read them here or open the PDF.

Open the PDFMost repeated EPD questions
Subject code
404185 B
Pattern
2019 pattern
Exam
Insem
Session
Oct 2022
Max. marks
30
Time
1 Hour
Semester
VII
Paper code
Oct-22/BE/Insem-99

Printed for: B.E. (E&TC)

Instructions to the candidates

  1. Answer Q1 or Q2, Q3 or Q4.
  2. Figures to the right indicate full marks.
  3. Neat diagram must be drawn wherever necessary.
  4. Assume suitable data, if necessary.

Questions

  1. Q1

    1. a)

      Explain concept development and its six stages.

      Also asked:Sep 2024 ·Sep 2023

      [5]
    2. b)

      Explain different tools and methods used for rapid prototyping.

      [5]
    3. c)

      Explain steps involved in Life Cycle cost analysis.

      [5]

  2. Q2

    1. a)

      Explain product design development in detail.

      Also asked:Sep 2023

      [5]
    2. b)

      What is rapid Prototyping? What are advantages of rapid prototyping?

      Also asked:Sep 2023

      [5]
    3. c)

      Explain design concerns and Heuristics.

      Also asked:Sep 2024

      [5]

  3. Q3

    1. a)

      Describe reliability. Which factors are considered for the calculation of failure rate?

      [5]
    2. b)

      Explain the following input interfaces to electronic products. i) Switches ii) Sensors iii) Alalog pre-processing circuits iv) A D C

      [5]
    3. c)

      Explain reliability. Write mathematical expressions for reliability of system and reliability of component. 2 BE/Insem-99

      [5]

  4. Q4

    1. a)

      Explain fault tolerance as phylosophy of system design and architecture using following areas. i) Careful design ii) Tastable functions. iii) Redundant architecture.

      [5]
    2. b)

      Explain methods to invistigate circuit operation to verity circuit design using. i) Bread boards, ii) Evolution boards iii) Prototype.

      [5]
    3. c)

      In high-speed circuit design, Explain the conservative criteria used to estimate when transmission line effects begin. 

      [5]