Irrigation & Drainage SPPU Endsem Question Paper Nov 2024
All 8 questions from this SPPU endsem paper, as printed. Read them here or open the PDF.
- Subject code
- 401013C
- Pattern
- 2019 pattern
- Exam
- Endsem
- Session
- Nov 2024
- Max. marks
- 70
- Time
- 2½ Hours
- Semester
- VIII
- Paper code
- [6354]-475
Printed for: B.E. (Civil)
Instructions to the candidates
- Attempt Q1 or Q2, Q3 or Q4, Q5 or Q6, Q7or Q8.
- Answers to the all questions should be written in single answer-book.
- Neat diagrams must be drawn wherever necessary.
- Figures to the right indicate full marks.
- Assume suitable data, jf necessary.
Questions
Q1
- a)[6]
Explain characteristic curves of centrifugal pump.
Also asked:Nov 2025
- b)[6]
What is the NPSH of centrifugal pump? Distinguish between available NPSH and required NPSH.
- c)[6]
Enlist component parts of lift irrigation system. Explain how to calculate power requirement of centrifugal pump in lift irrigation.
OR- a)
Q2
Q3
- a)[9]
- b)[8]
Determine the system capacity for a sprinkler irrigation system to irrigate 20 hectares of a crop. Design moisture use rate is 7mm/day. Moisture replaced in soil at each irrigation is 7.5 cm. Irrigation efficiency is 75 %. Irrigation period is 11 days in a 14-day interval. The system is to be operated for 19 hours per day. 2
ORQ4
- a)[6]
A sprinkler irrigation system is to be designed to irrigate 9 hectares of vegetables crops in deep silt loam soil in moderate dry climate. The field is flat. Determine the irrigation period, the net depth of water per application, the depth of water pumped per application and the required system capacity in hectare-cm per day. Assuming that the system is operated for 15 hours each day, determine the pump capacity in lit/sec. Assume following data: Limiting application rate = 1.35 cm/hr Moisture holding capacity of the soil = 9.7 cm/meter depth Root zone depth = 65 cm Irrigation to be stated at 50 % moisture depletion.
- b)[6]
Explain how to calculate power requirement of the pump in sprinkler irrigation system.
- c)[5]
Explain with neat sketch Fertilizer Applicator in sprinkler irrigation system.
- a)
Q5
- a)[5]
- b)[6]
Explain different engineering practices for salinity management.
- c)[6]
Estimate the leaching requirement when the electrical conductivity (EC) of the saturation extract of the soil is 11 mmhos/cm at 25 percent reduction in the yield of cotton. The EC of irrigated water is 1.5 mmhos/cm.
ORQ6
- a)[6]
What is leaching fraction? Explain how to compute leaching fraction.
- b)[5]
- c)[6]
A quantity of 100 ml of gypsum solution, having 29 meq/l concentration as calcium, on reacting with 6.5 gm of an alkali soil showed 30 meq/1 of Ca+Mg concentration in the filtrate. Estimate the gypsum requirement in meq/100 gm soil. 3
- a)
Q7
- a)[6]
- b)[8]
It is required to design surface drainage for a new agricultural farm to drain out irrigation tail-water and seasonal rainfall runoff. The maximum rainfall intensity at the site in 30 years record is 40mm/h. The tertiary drain would have to carry runoff from 6.5 ha land. The secondary drain would have to carry thrice of tertiary, and the main drain to carry discharge of five secondary drains (of similar flow). Determine the design discharge capacity of the i) tertiary ii) secondary and iii) main drain
- c)[4]
Enlist different types of drain pipes used for subsurface drainage and brief about anyone.
ORQ8
- a)[6]
- b)[3]
- c)[9]
This part has equations that don’t show as text. Open the PDF to read it.