Skip to content

Applied Thermodynamics important questionsMost repeated in SPPU papers

These 9 questions appeared in more than one SPPU Applied Thermodynamics paper we have: 7 papers, from Mar 2023 to Mar 2026. The most-asked come first. Each one links to the papers it was asked in.

Repeated questions

Endsem questions (9)

  1. 3×asked

    Explain battery ignition system and state its advantages and disadvantages.

    May 2024 ·Nov 2023 ·May 2023

  2. 2×asked

    A single stage single acting air compressor delivers 0.6 kg of air per minute at 6 bar. The temperature and pressure at the end of suction stroke are 30ºC and 1 bar respectively. The bore and stroke of the compressor are 100 mm and 150 mm respectively. The clearance is 3% of the swept volume. Assuming the index of compression and expansion to be n = 1.3. Find the following: i) Volumetric efficiency ii) Power required in mechanical efficiency is 85% and iii) Speed of the compressor.

    Nov 2025 ·Nov 2023

  3. 2×asked

    Explain with neat sketch wet sump lubrication system. State any six differences between wet sump and dry sump lubrication system.

    Nov 2025 ·May 2023

  4. 2×asked

    Draw p-  diagram and explain the different stages of combustion in SI engine.

    May 2024 ·May 2023

  5. 2×asked

    During the trial of a single cylinder, four stroke oil engine, the following results were obtained: Cylinder diameter = 20cm, stroke = 40cm, mean effective pressure = 6bar,Torque = 407 Nm, Speed = 250 rpm, Fuel consumption = 4 kg/hr., C.V. of fuel = 43 MJ/kg, Cooling water flow rate = 4.5 kg/min, Air used per kg of fuel =30 kg of air / kg of fuel, rise in cooling water temperature = 45 °C, Temperature of exhaust gases = 420 °C, Room temperature = 20 °C, Mean specific heat of exhaustgas = 1 kJ/kg-K, Specific heat of water = 4.18 kJ/kg-K.Calculate, IP, BP and draw heat balance sheet for the test.

    May 2024 ·May 2023

  6. 2×asked

    Explain with neat sketch pump assisted thermo-syphon water-cooling systems. Differentiate between air-cooling and water-cooling system.

    May 2024 ·May 2023

  7. 2×asked

    In a test of a four-cylinder petrol engine of 75mm bore and 100mm stroke, the following results were obtained at full throttle at a constant speed and with a fixedsetting of the fuel supply of 0.082 Kg/min. BP with all cylinder working = 15.24 kW, BP with cylinder I is cut-off = 10.45 kW, BP with cylinder 2 is cut-off = 10.38 kW, BP with cylinder 3 is cut-off = 10.23 kW, BP with cylinder 4 is cut-off = 10.35 kW, Find, i) Total indicated power of the engine, ii) Total friction power and iii) Indicated thermal efficiency of the engine if the CV of the fliel is 44MJ/Kg.

    May 2024 ·Nov 2023

  8. 2×asked

    What is ignition delay in CI engines? Explain any three factors affecting the ignition delay.

    May 2024 ·May 2023

  9. 2×asked

    What is multi-stage compression? Justify it save power required for compression as compared to single stage compression.

    May 2024 ·May 2023

Questions count as repeated when their wording matches closely across papers. Numericals that depend on a figure are left out, since the figure changes from paper to paper.