Fourth Year EngineeringMechanical EngineeringSemester 73 credits
Automobile DesignSPPU question papers (PYQ), solutions and notes
Automobile Design for Final Year (BE) Mechanical Engineering
Automobile Design is a semester 7 subject in Fourth Year Engineering, Mechanical Engineering, at Savitribai Phule Pune University (SPPU).
Here you’ll find 3 previous question papers (2024–2025).
Every question of 3 papers (Nov 2024 to Nov 2025) is written out on the paper pages below, so you don’t need to open a PDF.
Endsem papers are 70 marks (2½ hours). These are 2019-pattern papers.
Automobile Design previous year question papers
Pick a paper to read all its questions. No sign-in needed.
Most repeated Automobile Design questions
Asked in more than one SPPU paper, out of 3 we have.
- 3×asked
A semi-elliptic leaf spring used for automobile suspension consists of three extra full- length leaves and 15 graduated-length leaves, including the master leaf. The centre-to- centre distance between two eyes of the spring is 1 m. The maximum force that can act on the spring is 75 kN. For each leaf, the ratio of width to thickness is 9:1. The modulus of elasticity of the leaf material is 207000 N/mm 2 . The leaves are pre-stressed in such a way that when the force is maximum, the stresses induced in all leaves are same and equal to 450 N/mm 2 . Determine (i) the width and thickness of the leaves; (ii) the initial nip; and (iii) the initial pre-load required to close the gap C between extra fulllength leaves and graduated-length leaves.
- 3×asked
- 2×asked
- 2×asked
A propeller shaft is required to transmit 45 kW power at 500 rpm. It is a hollow shaft, having an inside diameter 0.6 times of outside diameter. It is made of plain carbon steel and the permissible shear stress is 84 N/mm 2 . Calculate the inside and outside diameters of the shaft.
- 2×asked
Automobile Design papers and notes
